Pogo pins make life so much easier when you are trying to program without having to solder a single thing, and when you attach them to an In-system programming (ISP) adapter they become instantly better, this simple kit allows you to do just that. Introducing the ISP Pogo Adapter, a simple and easy way to adapt pogo pins to a 6-pin ISP header allowing you to program an IC still without soldering a header to do so.
We’ve also included a labeled SIP header row and a 6-pin molex cable for you to be able to use your Arduino (or other single-board microcontroller) as an ISP device!
The ATtiny45 and 85 are a couple of really cool little MCUs but did you know you can program them in Arduino? That’s right, now you can shrink your Arduino projects down to “tiny size” by moving your code straight over to these small but capable ICs. The standard method for programming the ATtiny ICs involves a breadboard, lots of jumper wires and a hardware programmer, but David Mellis over at MIT Media Lab has simplified the process by laying out this handy USB programmer.
The Tiny AVR Programmer plugs directly into your USB port and provides a programming socket for the ATTiny45 and 85. J..
AVR-PG1B is programmer based on serial port PonyProg design. It takes the power supply from the target board. The connector is 2x5 pin with 0.1" step and Atmel STKxxx compatible layout.
Dimensions: 45x30 mm (1.7x1.2") + 20 cm (8") cable
Supported Devices: The currently supported devices by PonyProg software, which can be programmed by AVR-PG1B are:
AT90S2313, AT90S2323, AT90S2343
AT90S2323, AT90S2343, AT90S2333
ATmega103, ATmega161, ATmega163, ATmega323, ATmega128, ATmega8, ATmega16, ATmega64
MicroView, essentially an Arduino with a built-in display, is a tiny, enclosed piece of technology used to create a large assortment of electronics and programming projects. We understand that a lot of you really want to make the MicroView your own and get inside and reprogram it. We also, however, understand that that is not such an easy feat, luckily that’s where the MicroView Bootloading Kit comes in. This is an all-in-one kit that includes everything you will need to easily open and add, change, or remove a bootloader to/from your MicroView.
Each MicroView Bootloading Kit includes four ba..
AVR-ISP500 is a fast and reliable USB AVR programmer, and works directly with AVR Studio. It is recognized as a STK500 programmer and programs all AVRs. It emulates USB CDC so no drivers are required and works under Windows, Linux and MacOS. If you do not want to use AVRStudio you can use AVR-ISP500 with AVRdude.
Connects to PC via USB 2.0 Full speed
Uses Atmel’s 2x5 pin ICSP and 2x3 connector layout
45x30 mm (1.7x1.2") + 20 cm (8") cable
AVR ICSP 10 pin connector
This new version uses an SMD 5x2 header. This is a simple to use USB AVR programmer. It is low cost, easy to use, works great with AVRDude, and is tested extensively on a Windows desktop. Based on Dick Streefland’s USBtiny and Limor Fried’s USBtinyISP. This is a low-cost programmer designed for those on a tight budget.
This programmer works really well for ATmega168 and ATmega328 and should work with all the AVR micros supported by AVRDUDE. The microcontroller-to-be-programmed can be any AVR with 64K or less of flash. The ATmega328 on an Arduino Uno or RedBoard works perfectly, but the ATme..