This is the mother of all JTAG Programmers for ARMs - and it’s about 1/10th the price of other programmer/debuggers with the same functionality! This programmer/debugger is the first on market three-in-one USB JTAG debugger, offering JTAG; RS232 (full modem signals supported) port; and power supply all in one compact device.
It can be used as a power supply to ARM targets working in the voltage range of 2.0 to 5.0 V DC with three jumper selectable power supplies: 5V 9V and 12VDC. USB source current is limited with resetable fuse at 300mA, at the different output voltage the maximum current i..
This is a low cost USB-based JTAG programmer for ARM processors based on the OpenOCD platform.
Dimensions: 50x40 mm (2x1.6") + 20 cm (8") JTAG cable
Debug all ARM microcontrollers supported by OpenOCD
High speed USB 2.0 with lower lattency time, RTCK adaptive JTAG clock up to 30Mhz and higher throughput achieve x3-x5 times faster programming speed than ARM-USB-TINY, can be used with all ARM devices for programming and debugging.
Uses ARM’s standard 2x10 pin JTAG connector
supports ARM targets working in voltage range 2.0 – 5.0 V DC
software supported by OpenOCD (open source) debu..