quantity |
Stock Status | |
0 available immediately | |
401 available in 13 working days |
Stock code: COM-14195
These Clincher connectors from Amphenol FCI can be used to terminate Flat Flexible Cables (FFCs) to an easy-to-use standard header. Simply insert the end of the cable into the connector and press it closed. The teeth inside the connector will "clinch" around the conductors and break them out to two male 0.1" spaced pin headers!
Though the Clincher connector can be used with FFCs, we also like to use them with our FlexiForce sensors and other flex/force sensors found in the Recommended Products section below.
Note: Please be aware that we will not be able to accept returns on this connector if it has been closed. Sorry for any inconvenience this may cause.
Documents:
A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance across the sensor incre..
R437.00 (inc VAT)
This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and sh..
R57.00 (inc VAT)
This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and sh..
R148.50 (inc VAT)
This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its..
R125.00 (inc VAT)
This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its re..
R265.50 (inc VAT)
This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This F..
R153.00 (inc VAT)
This very long force sensitive resistor - over 2 feet - has a sensing area of 0.25x24". This FSR fro..
R523.00 (inc VAT)
A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor incre..
R199.00 (inc VAT)
This is a piezoresistive force sensor from Tekscan. The harder you press, the lower the sensor's res..
R624.50 (inc VAT)
An essential companion to the Chibi Chip, the Chibi Clip Mounting Accessory enables rapid testing an..
R265.50 (inc VAT)
These Clincher connectors from Amphenol FCI can be used to terminate Flat Flexible Cables (FFCs) to ..
R47.00 (inc VAT)
These Clincher connectors from Amphenol FCI can be used to terminate Flat Flexible Cables (FFCs) to ..
R23.50 (inc VAT)
These Clincher connectors from Amphenol FCI can be used to terminate Flat Flexible Cables (FFCs) to ..
R23.50 (inc VAT)